ATOM S30 PRODUCT VIDEO:

Description:

The all new ATOM marine series of amplifiers gives you the best of both worlds! Small footprint and big power! These amps also have great features like a built in volt meter and a microphone.

The ATOM S30 is a class A/B 4-Channel high power amplifier with 2 .400 watts peak output and 600 watts true RMS power. The RMS power is tested on a dyno using the certified run. It puts out 150 watts x 4 channels at less than 1% THD at 14.4 volts. We give the true power and the peak rating so you can easily compare this amp to any brand on the market regardless of how they like to rate their products.The peak rating can be used to compare with brands who use peak ratings such as Boss and Power Acoustik while the Dyno Certified RMS rating can be used to compare with top brands such as Kicker . Rockford . Alpine . etc.

The ATOM S30 includes a PA microphone allowing you to make announcements to your friends and family. This is important for safety and it is also fun.

This amp has enough juice to power either (8) speakers . (4) speakers . (2) subwoofers or a combination of subwoofers and speakers.

What’s in the Box:

Amplifier
PA microphone
Birth sheet with Dyno-tested power
Mounting Screw Kit
Owner’s manual
Warranty

Features:

Rockville ATOM S30 2400 Watt Peak/600 Watt Dyno-Certified RMS 4 Channel Class AB Marine Stereo Amplifier
Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker . Rockford Fosgate . etc)
2 Ohm: 150 Watts x 4 Channel <1% THD+N @ 14.4 Volts
4 Ohm: 100 Watts x 4 Channel <1% THD+N @ 14.4 Volts
4 Ohm Bridged: 300 Watts x 2 Channel <1% THD+N @ 14.4 Volts
Peak: (Use these ratings when comparing with the top budget brands such as Boss . Power Acoustik . etc)
2 Ohm: 600 Watts x 4 Channel
4 Ohm: 400 Watts x 4 Channel
4 Ohm Bridged: 1200 Watts x 2 Channel
Digital Voltage Display on Amp
Microphone input and PA microphone included
Adjustable Low Pass Filter: 50Hz – 250Hz
Adjustable High Pass Filter: 50Hz – 250Hz
Painted Conformal Coating PCB Board (Uses 2577 Waterproof Glue)
Rustproof Aluminum heat sink with silver hairline finish
Stainless steel end panels are rustproof
All screws and mounting hardware are stainless steel and rustproof
Bottom panel is aluminum and rustproof
4 Gauge power and ground terminals
10 Gauge speaker wire terminals
All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers
All channels on the amplifier are bridgeable
High-Speed MOSFET Power Supply
Under Voltage Protection at 10V
Over Voltage Protection at 16V
Tertiary Supplies Circuitry
Studio-Grade Bipolar Output Stage Transistors
Fully Adjustable 12dB / Octave Crossover with Differential Circuitry
Full IC-Controlled Protection Circuitry
Fully Adjustable 12dB Bass Equalizer
Adjustable Input Level Control
Mute and Delay Soft Start System
2CH/4CH Input Mode Switch
RCA Lin